01246 860214 / +44 114 360 8898. info@fabworxuk.com

Double – M1 Tested- Rock&Roll Bed – M010

£600.00

Please See Details And Video’s Below:

SKU: M010-T Categories: , Tags: , ,

Full M1 strength and quality tested double seat / sliding bed frame supplied with full test certificate and x4 under vehicle fitting plates

Full seat belt pack included and fitted

This frame passed with the highest results during all test procedures

Fitted with a 4 stage recline system

Gas ram assistance when returning to a seat

Quick release and self raising function simply push 4 stage recline handle downwards to watch it self rise
 
Heavy duty runners that can hold 100kgs on the end when in bed position


Can make for left and right hand drive

Sizes

In seat position
Width 1100mm
Length 890mm
Height 400mm base
Height 1080mm to top of back rest from the floor

In bed position
Width 1100mm
Length 1865mm
Height excluding hinges 400mm

This will be sold black with a black handle but these can be any colour to suit your conversion interior as shown in picture. Small additional cost for this

Extras available
Installation at our chesterfield workshop £100
Different frame colour £50
Custom colour handle £15
Different coloured seat belts £20 extra
Green,red,blue,yellow ect. Other colour options

Fabrication and assembly time ready for delivery or collection 10/12 days if stock levels are low.

Additional information

Frame Colour

Black, Coloured

Coloured Seat Belts

Yes, No

Fitting

Yes, No

Reviews

There are no reviews yet.

Be the first to review “Double – M1 Tested- Rock&Roll Bed – M010”

Your email address will not be published. Required fields are marked *

New

M1 Tested

Features

  • No front legs
  • Fitting with accuride heavy duty runners
  • Zero rattles when in driving seat position or bed
  • Black plastic caps fitted to nuts
  • Semi-Automatic.
  • From seat to bed to seat again in less then 10 seconds.
  • Supplied with full fitting kit £19.99 usually
  • Full seat belt pack prefitted
  • Multi fitting base to fit most vehicles
  • *always check measurements before hand and leave at least a 20mm gap each side
    custom pressurized gas ram
    How to use,
    Remove the transit locking knob by turning anti clockwise pull bed forward and push down into bed position. To bring it back up into seat position lightly pull up the back rest up and the gas ram takes over and pulls it back to a seat. re insert the transit knob. ready for passengers to use (spare transit knob fitted to inside of base)

F010

 Sizes

Bed Frame No MO1O
SEATS Double
BASE LENGTH 1070MM
BASE WIDTH 840MM
BASE HEIGHT 365MM
BED WIDTH 1140MM
BED LENGTH 1750MM
BACK REST HEIGHT 1000MM
UPHOLSTERY BED LENGTH 1835MM